EasyManuals Logo

HP 5500 EI series User Manual

HP 5500 EI series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #357 background imageLoading...
Page #357 background image
346
Configuring OSPFv3 route redistribution
Because OSPFv3 is a link state routing protocol, it cannot directly filter LSAs to be advertised. OSPFv3
filters only redistributed routes. Only routes that are not filtered out can be advertised in LSAs.
Executing the import-route or default-route-advertise command on a router makes it become an ASBR.
To configure OSPFv3 route redistribution:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
N/A
3. (Optional.) Specify a default
cost for redistributed routes.
default cost value The default setting is 1.
4. Configure OSPFv3 to
redistribute routes from other
routing protocols.
import-route protocol [ process-id |
all-processes | allow-ibgp ] [ cost cost |
route-policy route-policy-name | type
type ] *
By default, route redistribution
is disabled.
5. (Optional.) Configure
OSPFv3 to redistribute a
default route.
default-route-advertise [ [ always |
permit-calculate-other ] | cost cost |
route-policy route-policy-name | type
type ] *
By default, no default route is
redistributed.
This command can only inject
and advertise a default route.
6. (Optional.) Configure
OSPFv3 to filter redistributed
routes.
filter-policy { acl6-number | prefix-list
prefix-list-name } export [ protocol
[ process-id ] ]
By default, OSPFv3 accepts
all redistributed routes.
This command filters only
routes redistributed with the
import-route command. If the
import-route command is not
configured, executing this
command does not take
effect.
Tuning and optimizing OSPFv3 networks
This section describes configurations of OSPFv3 timers, interface DR priority, and the logging of
neighbor state changes.
Configuration prerequisites
Before you tune and optimize OSPFv3 networks, complete the following tasks:
• Configure IPv6 addresses for interfaces to ensure IPv6 connectivity between neighboring nodes.
• Enable OSPFv3.

Table of Contents

Other manuals for HP 5500 EI series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5500 EI series and is the answer not in the manual?

HP 5500 EI series Specifications

General IconGeneral
BrandHP
Model5500 EI series
CategorySwitch
LanguageEnglish

Related product manuals