HP 5500 EI series User Manual

345
Ste
p
Command Remarks
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an OSPFv3
cost for the interface.
ospfv3 cost value [ instance
instance-id ]
By default, the OSPFv3 cost is 1 for a VLAN
interface, is 0 for a loopback interface, and is
automatically computed according to the
interface bandwidth for other interfaces.
To configure a bandwidth reference value:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value The default setting is 100 Mbps.
Configuring the maximum number of OSPFv3 ECMP routes
Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
N/A
3. Specify the maximum number
of ECMP routes.
maximum load-balancing
maximum
The default setting depends on the
device model.
Configuring a preference for OSPFv3
A router can run multiple routing protocols. The system assigns a priority for each protocol. When these
routing protocols find the same route, the route found by the protocol with the highest priority is selected.
To configure a preference for OSPFv3:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Configure a preference
for OSPFv3.
preference [ ase ] [ route-policy
route-policy-name ] preference
By default, the preference of OSPFv3
internal routes is 10, and the priority of
OSPFv3 external routes is 150.

HP 5500 EI series Specifications

General

Brand	HP
Model	5500 EI series
Category	Switch
Language	English