HP 5500 EI series User Manual

229
Ste
p
Command Remarks
4. Specify the maximum number
of BGP ECMP routes for load
balancing.
balance number
By default, load balancing is
disabled.
To specify the maximum number of BGP ECMP routes for load balancing (IPv6):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv6 unicast
address family view or
BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
4. Specify the maximum number
of BGP ECMP routes for load
balancing.
balance number
By default, load balancing is
disabled.
Configuring IPsec for IPv6 BGP
Perform this task to configure IPsec for IPv6 BGP. IPsec can provide privacy, integrity, and authentication
for IPv6 BGP packets exchanged between BGP peers.
When two IPv6 BGP peers are configured with IPsec (for example, Device A and Device B), Device A
encapsulates an IPv6 BGP packet with IPsec before sending it to Device B. If Device B successfully
receives and de-encapsulates the packet, it establishes an IPv6 BGP peer relationship with Device A and
learns IPv6 BGP routes from Device A. If Device B receives but fails to de-encapsulate the packet, or
receives a packet not protected by IPsec, it discards the packet.
To configure IPsec for IPv6 BGP packets:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPsec transform
set and a manual IPsec
profile.
See Security Configuration Guide.
By default, no IPsec transform set or
manual IPsec profile exists.
3. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
Use either method.

HP 5500 EI series Specifications

General

Brand	HP
Model	5500 EI series
Category	Switch
Language	English