321
Configuring an IPv6 default route
A default IPv6 route is used to forward packets that match no entry in the routing table.
A default IPv6 route can be configured in either of the following ways:
• The network administrator can configure a default route with a destination prefix of ::/0. For more
information, see "Configuring an IPv6 static route."
• Some dynamic routing protocols, such as OSPFv3, IPv6 IS-IS, and RIPng, can generate a default
IPv6 route. For example, an upstream router running OSPFv3 can generate a default IPv6 route and
advertise it to other routers, which install the default IPv6 route with the next hop being the upstream
router. For more information, see the respective chapters on those routing protocols in this
configuration guide.
To Next Page
Loading...
Need help?
General