HP 5500 EI series User Manual

139
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Disable source address
check for hello packets on
a PPP interface.
isis peer-ip-ignore
By default, a PPP interface checks the
source IP address in hello packets.
The command applies only to PPP
interfaces.
Disabling an interface from sending/receiving IS-IS packets
After being disabled from sending and receiving hello packets, an interface cannot form any neighbor
relationship, but can advertise directly connected networks in LSPs through other interfaces. This can save
bandwidth and CPU resources, and ensures that other routers know networks directly connected to the
interface.
To disable an interface from sending and receiving IS-IS packets:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Disable the interface from
sending and receiving IS-IS
packets.
isis silent
By default, the interface can send
and receive IS-IS packets.
Enabling an interface to send small hello packets
IS-IS messages cannot be fragmented at the IP layer because they are directly encapsulated in frames.
Any two IS-IS neighboring routers must negotiate a common MTU. To avoid sending big hellos to save
bandwidth, enable the interface to send small hello packets without CLVs.
To enable an interface to send small hello packets:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the interface to send
small hello packets without
CLVs.
isis small-hello
By default, the interface can send
standard hello packets.

HP 5500 EI series Specifications

General

Brand	HP
Model	5500 EI series
Category	Switch
Language	English