330
Task Command
Reset a RIPng process. reset ripng process-id process
Clear statistics of a RIPng process. reset ripng process-id statistics
RIPng configuration examples
Basic RIPng configuration example
Network requirements
As shown in Figure 83, all routers learn IPv6 routing information through RIPng. Configure Router B to
filter the route (2::/64) learned from Router A, which means the route will not be added to the routing
table of Router B, and Router B forwards only the route 4::/64 to Router A.
Figure 83 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic RIPng:
# Configure Router A.
<RouterA> system-view
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ripng 1 enable
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ripng 1 enable
[RouterA-Ethernet1/2] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ripng 1
[RouterB-ripng-1] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ripng 1 enable
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] ripng 1 enable
[RouterB-Ethernet1/2] quit
To Next Page
Loading...
Need help?
General