HP 5500 EI series User Manual

389
You can apply only one policy to an interface. Before you apply a new policy, you must first remove the
current policy from the interface.
You can apply a policy to multiple interfaces.
To configure IPv6 interface PBR:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Apply an IPv6
policy to the
interface.
ipv6 policy-based-route policy-name
By default, no IPv6 policy is
applied to the interface.
Displaying and maintaining IPv6 PBR
Execute display commands in any view and reset commands in user view.
Task Command
Display IPv6 PBR policy information. display ipv6 policy-based-route [ policy policy-name ]
Display IPv6 PBR configuration. display ipv6 policy-based-route setup
Display IPv6 local PBR configuration and
statistics (MSR2000/MSR3000).
display ipv6 policy-based-route local
Display IPv6 local PBR configuration and
statistics (MSR4000).
display ipv6 policy-based-route local [ slot slot-number ]
Display IPv6 interface PBR configuration and
statistics (MSR2000/MSR3000).
display ipv6 policy-based-route interface interface-type
interface-number
Display IPv6 interface PBR configuration and
statistics (MSR4000).
display ipv6 policy-based-route interface interface-type
interface-number [ slot slot-number ]
Clear IPv6 PBR statistics. reset ipv6 policy-based-route statistics [ policy policy-name ]
IPv6 PBR configuration examples
Packet type-based IPv6 local PBR configuration example (on
routers)
Network requirements
As shown in Figure 94, configure IPv6 PBR on Router A to forward all TCP packets to the next hop 1::2.
Router A forwards other packets according to the routing table.

HP 5500 EI series Specifications

General

Brand	HP
Model	5500 EI series
Category	Switch
Language	English