4. Slide the graphics board heat sink (4) up and forward at an angle and remove it.
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the graphics
board heat sink and the graphics board each time the graphics board heat sink is removed:
Thermal paste is used on the largest component (1) on the graphics board and the graphics
board heat sink section (2) that services it. Thermal pads are used on the other graphics board
components (3) and the graphics board heat sink sections (4) that service them.
Reverse this procedure to install the graphics board heat sink.
68 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
