4. Pull the release lever next to the rear of the HDD away from the HDD (2). While pulling the release lever
out, slide the drive back until it stops, then lift the HDD up and out of the cage (3).
5. To install a HDD, you must transfer the silver and blue isolation mounting guide screws from the old HDD
to the new HDD.
6. Align the guide screws with the slots on the chassis drive cage, press the HDD down into the cage, then
slide it forward until it stops and locks in place (1).
24 Chapter 4 Removal and replacement procedures – desktop mini (DM) chassis
To Next Page
Loading...
Need help?
General