NOTE: The monitor automatically determines which inputs have valid video signals. You can select
inputs by pressing the Menu button to access the on-screen display (OSD) menu and then selecting
Input control.
● Connect one end of a VGA cable to the VGA port on the rear of the monitor and the other end to the
VGA port on the source device.
● Connect one end of a USB Type-B cable to the USB Type-B upstream port on the rear of the monitor
and the other end to the USB Type-A port on the source device. This enables video and data pass-
through.
NOTE: DisplayLink drivers are required for this setup. Drivers are available on the HP Support
website.
Setting up the monitor 9
To Next Page
Loading...
