HP EliteDisplay E243d 23.8 - Page 34

2. Add a second monitor by connecting a DisplayPort cable between the DisplayPort OUT port on the
primary monitor and the DisplayPort IN port on a secondary monitor. The secondary monitor should not
be the same model as the primary monitor.
NOTE: Three of the four daisy-chained monitors need to have DisplayPort IN and OUT video ports. The
last monitor in the chain needs only a DisplayPort IN video port.
3. Set a connected monitor to display the same image as the primary monitor or a dierent image.
DisplayPort 1.1 is the default setting, but the setting automatically changes to DisplayPort 1.2 when
DisplayPort OUT is connected to the secondary monitor.
4. To connect additional monitors (up to four maximum), press the Menu button to open the OSD menu.
Navigate to the USB Type-C conguration and select USB-C Video+USB2.0.
NOTE: All but the nal monitor in the chain must support DisplayPort multistreaming.
5. Connect the DisplayPort cable from the DisplayPort OUT port of one monitor to the DisplayPort IN port
of the next monitor.
6. If you want dierent information on each screen, be sure that all upstream monitors are congured to
DisplayPort 1.2 mode, as described previously.
26 Chapter 2 Using the monitor