NOTE: The display hinges are available using spare part number 807525-001.
a. Position the display enclosure upright.
b. Remove the Phillips PM2.0×2.5 screw (1) from the top of each hinge and the four broadhead
Phillips PM2.5×3.0 screws (2) from the bottom of each hinge that secure the hinges to the display.
c. Rotate the top of the hinges inward so that the hinges are at an angle, (3), and then remove the
hinges (4).
4. To remove the G sensor board:
NOTE: The G sensor board is available using spare part number 807530-001.
a. Pull the tape from atop the G sensor board (1).
b. Lift the board enough to be able to grasp it (2).
52 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
