HP ESG Series - Page 4

Contents
1. Getting Started
The Signal Generator at a Glance
.................................... l-2
Creating an FM Signal.
............................................
l-3
Setting the Carrier Frequency.
................................... 1-3
Setting the Power Level.
........................................ 1-3
Setting the FM Deviation
....................................... l-4
Setting the FM Rate.
........................................... 1-4
Turning On Frequency Modulation.
............................... l-4
Creating a Step Sweep and a List Sweep
.............................. 1-5
Configuring a Step Sweep
....................................... 1-5
Turning On Continuous Step Sweep.
.............................. l-6
Configuring a List Sweep Using Step Sweep Data
................... 1-7
Turning On List Sweep for a Single Sweep
......................... 1-8
Saving and Recalling an Instrument State.
............................
l-9
Creating an Instrument State.
................................... l-9
Saving an Instrument State
..................................... l-10
Recalling an Instrument State
................................... l-10
Setting Up a Digital Modulation in the GSM Format
.................... l-11
Setting the Carrier Frequency.
................................... l-11
Setting the Power Level.
........................................ l-11
Selecting the Data Format.
...................................... 1-12
Setting Up Timeslot 0
.......................................... 1-12
Setting Up Timeslot 7
.......................................... 1-13
Turning On the GSM Format and the Modulation
................... 1-14
2. Exploring the User Interface
Front Panel ......................................................
2-2
Display ..........................................................
2-7
RearPanel .......................................................
2-12
Quick Start Guide
. . .
III