HP FlexFabric 5940 - Page 16

13
Step Command Remarks
7. Enter interface view.
interface
interface-type
interface-number
N/A
8. Enable the IS-IS
process on the
interface.
isis enable
[ process-id ]
By default, no IS-IS process is
enabled on the interface.
Configuring EBGP between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance
view.
bgp
as-number [
instance
instance-name ]
[
multi-session-thread
]
By default, BGP is not
enabled.
3. Enter BGP-VPN
instance view.
ip vpn-instance
vpn-instance-name N/A
4. Configure the PE as an
EBGP peer.
peer
{ group-name | ipv4-address
[ mask-length ] }
as-number
as-number
By default, no BGP peers or
peer groups exist.
5. Enter BGP-VPN IPv4
unicast address family
view.
address-family ipv4
[
unicast
] N/A
6. Enable BGP to
exchange IPv4 unicast
routes with the peer.
peer
{ group-name | ipv4-address
[ mask-length ] }
enable
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
7. Redistribute the VPN
routes of the VPN site.
import-route
protocol [ process-id |
all-processes
] [
allow-direct
|
med
med-value |
route-policy
route-policy-name ] *
By default, no routes are
redistributed into BGP.
Configuring IBGP between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view.
bgp
as-number [
instance
instance-name ]
[
multi-session-thread
]
By default, BGP is not
enabled.
3. Enter BGP-VPN instance
view.
ip vpn-instance
vpn-instance-name N/A
4. Configure the PE as an IBGP
peer.
peer
{ group-name | ipv4-address
[ mask-length ] }
as-number
as-number
By default, no BGP peers or
peer groups exist.
5. Enter BGP-VPN IPv4 unicast
address family view.
address-family ipv4
[
unicast
] N/A
6. Enable BGP to exchange
IPv4 unicast routes with the
peer.
peer
{ group-name | ipv4-address
[ mask-length ] }
enable
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
7. Redistribute the VPN routes
of the VPN site.
import-route
protocol [ process-id |
all-processes
] [
allow-direct
|
med
med-value |
route-policy
route-policy-name ] *
By default, no routes are
redistributed into BGP.