31
Step Command Remarks
[ next-hop-address ] | nexthop-address [
public
]
|
vpn-instance
d-vpn-instance-name
nexthop-address } [
permanent
] [
preference
preference ] [
tag
tag-value ] [
description
text ]
3. (Optional.) Set the
default preference for
IPv6 static routes.
ipv6 route-static default-preference
default-preference
The default value is 60.
Configuring RIPng between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view.
ripng
[ process-id ]
vpn-instance
vpn-instance-name
N/A
3. Redistribute VPN routes.
import-route
protocol
[
process-id
]
[
allow-ibgp
] [
allow-direct
|
cost
cost-value
|
route-policy
route-policy-name ] *
By default, no routes are
redistributed into RIPng.
4. Return to system view.
quit
N/A
5. Enter interface view.
interface
interface-type
interface-number
N/A
6. Enable the RIPng process on
the interface.
ripng
process-id
enable
By default, RIPng is disabled
on an interface.
Configuring OSPFv3 between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an OSPFv3 process
for an IPv6 VPN instance
and enter OSPFv3 view.
ospfv3
[ process-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Set the router ID.
router-id
router-id N/A
4. Disable routing loop
detection.
vpn-instance-capability simple
By default, routing loop detection
is enabled.
On an MCE network, you must
disable routing loop detection for
a VPN OSPFv3 process.
Otherwise, the MCE does not
receive OSPFv3 routes from the
PE.
5. Redistribute VPN routes.
import-route
protocol
[ process-id |
all-processes
|
allow-ibgp
] [
allow-direct
|
cost
cost-value |
nssa-only
|
route-policy
route-policy-name |
tag
tag |
type
type ] *
By default, no routes are
redistributed into OSPFv3.
6. Return to system view.
quit
N/A
7. Enter interface view.
interface
interface-type
interface-number
N/A
8. Enable the OSPFv3 process
ospfv3
process-id
area
area-id By default, OSPFv3 is disabled on
To Next Page
Loading...
