6 HP Fast InfraRed Receiver
EN
7 Press Select to print the configuration page.
The configuration page shows the printer’s current
configuration.
An HP JetDirect network configuration page will also print
for networked printers and mopiers.
A configuration summary prints. On the first page of the
printout, under
Installed Personalities and Options
, check
for “IR POD (IrDA-Compliant).”
The HP Fast InfraRed Receiver can be placed on a table or
attached to the side of the printer using the Velcro fasteners
shown in Figure 3 on page 7.
To attach the HP Fast InfraRed Receiver on the side of the
printer, continue with steps 1 and 2.
1 Attach one Velcro faster to the round depression on the
underside of the HP Fast InfraRed Receiver (see
Figure 3).
2 Attach the remaining Velcro fastener to the side of the
printer (see Figure 3).
When the HP Fast InfraRed Receiver is situated on the
printer, it should be close to the printer’s front edge as shown
in Figure 4. This location allows for the largest possible area
in which the portable computer’s IR port can operate. The
required alignment of devices is described in “Executing the
Print Job” on page 10.
To Next Page
Loading...
Need help?
General
