HP HP-97 - Page 42

Assembly-Level Maintenance
2.
Battery Door Latch Removal/Replacement
Perform removal step 1.
Lift inside tab over ridge and slide
latch out.
To replace latch, slide latch into
slot until it snaps over ridge.
Note: Make certain the foam tape is
securely in place on the door. It holds
the battery firmly in place.
Bottom Case Assembly Removal
Perform removal/replacement
procedure 1.
Remove the six Phillips screws as
shown.
Lift off the bottom case.
Rubber Feet Removal/Replacement
Grasp each rubber foot firmly with
needle-nose pliers.
Pull out firmly to remove.
HP-97
Firmly press in new feet
while being careful not to
damage bottom case.
Cut off excess rubber.