HP HP-97 - Page 44

Assembly-Level
Maintenance
HP-97
b. Remove the card reader cable from
the connector on the logic board by
inserting the large end of the
connector tool (T-155435) into the
connector and then pulling the cable
free.
During reassembly, insert the cable
together with the connector tool
into the connnector; then remove the
cable tool.
Note: The cable should be positioned with its contacts facing the top of
the connector, and the connector tool should be positioned between these
contacts and the connector.
c. Carefully disconnect the battery
leads (one red/white and one red)
from one side of the logic
printed-circuit board, and the three
paper advance switch leads (one red,
one black, and one white) from the
other side of the board.
RED
RED/WHITE
WHITE
WHITE
d. Lift off the logic printed-circuit
assembly.