HP X240 10G SFP+ to SFP+ 0.65m Direct Attach Copper Cable
JD095C
HP X240 10G SFP+ to SFP+ 1.2m Direct Attach Copper Cable
JD096C
HP X240 10G SFP+ to SFP+ 3m Direct Attach Copper Cable
JD097C
HP X240 10G SFP+ SFP+ 7m Direct Attach Copper Cable
JC784C
HP X240 10G SFP+ to SFP+ 5m Direct Attach Copper Cable
JG081C
HP X240 10G SFP+ SFP+ 7m Direct Attach Copper Cable
JC784C
Note 2
The following Transceivers install into this Module: (Use #0D1 if switch is CTO)
HP X135 10G XFP LC ER Transceiver
JD121A
HP X130 10G XFP LC LR Single Mode 10km 1310nm Transceiver
JD108B
HP X130 10G XFP LC SR Transceiver
JD117B
Note 3
The following Transceivers install into this Module: (Use #0D1 if switch is CTO)
HP X120 1G SFP LC SX Transceiver
JD118B
HP X120 1G SFP LC LX Transceiver
JD119B
HP X120 1G SFP RJ45 T Transceiver
JD089B
HP X120 1G SFP LC BX 10-U Transceiver
JD098B
HP X120 1G SFP LC BX 10-D Transceiver
JD099B
HP X125 1G SFP LC LH40 1310nm Transceiver
JD061A
HP X120 1G SFP LC LH40 1550nm Transceiver
JD062A
HP X125 1G SFP LC LH70 Transceiver
JD063B
Note 4
The following Cables install into this Module: (Use #B01 if switch is CTO)
HP X230 Local Connect 50cm CX4 Cable
JD363B
HP X230 Local Connect 100cm CX4 Cable
JD364B
HP X230 CX4 to CX4 3m Cable
JD365A
Note: Two JD365A - HP X230 CX4 to CX4 3m Cable should be added by default if Module is selected.
Note 5
If factory intergrated into the switch, This Module must be ordered as #0D1 when the switch is
not Factory Racked
Note 6
If factory intergrated into the switch, This Module must be ordered as #B01 when the switch is
Factory Racked (Rack Level Integration CTO).
Transceivers
SFP Transceivers
HP X120 1G SFP LC SX Transceiver
JD118B
HP X120 1G SFP LC LX Transceiver
JD119B
HP X120 1G SFP RJ45 T Transceiver
JD089B
QuickSpecs
HP 5120 EI Switch Series
Configuration
DA - 13850 Worldwide — Version 26 — April 15, 2014
Page 18
To Next Page
Loading...
