HP Jetdirect 610N - Resetting to Factory Defaults

116 Troubleshooting the HP Jetdirect Print Server EN
Resetting to Factory Defaults
Parameters on the HP Jetdirect print server (for example, the
IP address) can be reset to factory default values using the following
procedures:
●
HP LaserJet Printer with Internal EIO Print Server
In most cases, the HP Jetdirect internal print server can be reset
to factory defaults when a cold-reset is performed on the printer.
For selected HP LaserJet printers, a cold-reset is performed by
power cycling the printer while pressing the Go button. For other
printers, refer to your printer manuals.
Note Some printers provide a factory reset option for
the printer through the printer’s control panel.
However, this reset option for the printer may not
reset the HP Jetdirect print server. When you
attempt to reset to factory default values, print a
Jetdirect Configuration Page to confirm that
factory-reset values have been assigned.
CAUTION Resetting the printer will reset all printer settings
to their factory defaults. After resetting the printer,
you may need to use the printer's control panel to
reconfigure printer settings that are required by
users.
●
HP Jetdirect External Print Servers
Reset the HP Jetdirect external print server by holding down the
[Test] button on the print server while connecting the power cord.
After resetting the HP Jetdirect print server, you may need to
reconfigure your computers for printing.