HP Jetdirect 610N - Page 143

EN HP Jetdirect Configuration Page 143
➏
AppleTalk Protocol Information
Information in this section of the Jetdirect configuration page
(Ethernet Only) is described in Table 8.6
. For error messages,
see Table 8.9
.
Table 8.6
➏
AppleTalk Configuration Information
Message Description
STATUS: Indicates the current AppleTalk configuration status.
READY: Indicates the HP Jetdirect print server is awaiting
data.
DISABLED: Indicates that AppleTalk was manually
disabled.
INITIALIZING: Indicates that the print server is registering
the node address or name. An additional status message
may also be displayed.
An Error Code and Message is displayed if the print server
is not ready. For more information, see Table 8.9
.
NAME: The name of the printer on the AppleTalk network. A
number after the name indicates that there are multiple
devices with this name, and this is the Nth instance of the
name.
ZONE: The name of the AppleTalk network zone on which the
printer is located.
TYPE: The type of the printer being advertised on the network.
Two types can be displayed.
NETWORK
NUMBER:
NODE NUMBER:
NETWORK NUMBER: identifies the AppleTalk Network
Number on which the HP Jetdirect print server is currently
operating.
NODE NUMBER: identifies the AppleTalk Node Number
that the print server chose for itself as part of its
initialization sequence.
Note: The AppleTalk phase 2 (P2) parameter is
preconfigured on the HP Jetdirect print server.