HP Jetdirect 610N - Page 175

EN Using the Embedded Web Server 175
[Networking] Tab
The Networking page provides access to HP Jetdirect network
configuration parameters and status.
Network Settings
The Network Settings pages allow you to set or change
configuration parameters for TCP/IP, IPX/SPX, AppleTalk,
DLC/LLC, and SNMP protocols. To assign a parameter setting,
enter the desired value and click Apply.
TCP/IP
The TCP/IP page provides configuration parameters summarized
in Table B.2
.
Table B.2 TCP/IP Settings (1 of 3)
Item Description
IP Configuration
Method
Selects the method that the HP Jetdirect print server will receive
its IP configuration parameters: BOOTP (default), DHCP, or
Manual.
For BOOTP or DHCP, the IP parameters will be automatically
configured by a BOOTP or DHCP server each time the print
server is powered on.
If you select “Manual”, then basic IP parameters can be manually
entered using this web page, or using other available tools (see
Chapter 3
.)
Host Name Specifies a readable IP name (the SNMP SysName object) for
the network device. The name must start with a letter and can
end in a letter or number, up to 32 ASCII characters.
IP Address Use this field to manually assign the Internet Protocol address
on the HP Jetdirect print server. The IP address is a four byte
(32-bit) address in the form "n.n.n.n", where 'n' is a number from
0 to 255.
An IP address uniquely identifies a node on a TCP/IP network.
Duplicate IP addresses on a TCP/IP network are not allowed. For
more information on IP addresses, see Appendix A
.