HP Jetdirect 610N - Page 188

188 The HP Jetdirect EIO Control Panel Menu EN
Table C.1 HP Jetdirect EIO Control Panel Menu (1 of 2)
Jetdirect Internal Print
Server Menu Item
Description
CFG NETWORK=NO* Selects whether or not you want to access the Jetdirect
menu.
NO* (default): Bypass the HP Jetdirect menu.
YES*: Access the HP Jetdirect menu. You must change
this to YES* each time you want to access the menu.
IPX/SPX=ON*
DLC/LLC=ON*
TCP/IP=ON*
ATALK=ON*
Identifies whether the protocol stack is enabled or
disabled.
ON* (default). The protocol is enabled.
OFF*: The protocol is disabled.
CFG IPX/SPX=NO* Selects whether you want to access the IPX/SPX menu
and set IPX/SPX protocol parameters.
NO* (default): Bypass the IPX/SPX menu items.
YES*: Access the IPX/SPX menu items.
In the IPX/SPX menu, you can specify the Frame Type
parameter used on your network.
■
AUTO (default) will automatically set and limit the
frame type to the first one detected.
■
For Ethernet cards, frame type selections include
EN_8023, EN_II, EN_8022, EN_SNAP.
■
For Token Ring cards, frame type selections
include TR_8022, TR_SNAP.
In the IPX/SPX menu for Token Ring cards, you can also
specify NetWare Source Routing parameters, which
include SRC RT=AUTO (default), OFF, SINGLE R, or
ALL RT.