HP Jetdirect 610N - Page 189

EN The HP Jetdirect EIO Control Panel Menu 189
CFG TCP/IP=NO* Selects whether you want to access the TCP/IP menu
and set TCP/IP protocol parameters.
NO* (default): Bypass the TCP/IP menu items.
YES*: Access the TCP/IP menu items.
In the TCP/IP menu, you can specify BOOTP=YES* or
DHCP=YES* for TCP/IP parameters to be automatically
configured by a BootP or DHCP server when the printer
is turned on.
If you specify BOOTP=NO* and DHCP=NO*, you can
manually set the following TCP/IP parameters from the
control panel:
■
Each byte of the IP address (IP)
■
Subnet Mask (SM)
■
Syslog Server (LG)
■
Default Gateway (GW)
■
Idle Timeout period (default is 270 seconds,
0 disables the timeout)
Print a Jetdirect configuration page to verify your settings.
However, note that the print server may overwrite
selected parameters with values that ensure proper
operation.
CFG LINK=NO* Selects whether you want to manually configure the
HP Jetdirect 10/100Base-TX print server’s network link
speed and communication mode. The Jetdirect settings
must match the network.
NO* (default): Bypass the link configuration menu items.
YES*: Access the link configuration menu items.
One of the following link configuration can be set:
AUTO* (default): The print server will automatically
configure itself to match the network’s link speed and
communication mode.
10T HALF*: 10Mbps, half-duplex operation.
10T FULL*: 10 Mbps, full-duplex operation.
100T HALF*: 100 Mbps, half-duplex operation
100T FULL*: 100 Mbps, full-duplex operation
Table C.1 HP Jetdirect EIO Control Panel Menu (2 of 2)
Jetdirect Internal Print
Server Menu Item
Description