EN TCP/IP Configuration 47
ipp-printing:
Enables or disables the ability to print via IPP: 0 disables, 1 (default) enables.
lpd-printing:
Enables or disables LPD (Line Printer Daemon) printing services on the Jetdirect
print server. 0 disables, 1 (default) enables.
banner:
A port-specific parameter that specifies printing an LPD banner page. 0 disables
banner pages. 1 (default) enables banner pages.
interlock:
Specifies whether an acknowledgement (ACK) on all TCP packets is required
before the printer is allowed to close a Port 9100 print connection. To
accommodate multiport print servers, a Port Number and Option value are
specified. Port Numbers can be 1 (default), 2, or 3. Option value 0 (default)
disables interlock, 1 enables. For example,
“interlock 2 1” specifies Port 2, interlock enabled
buffer-packing:
Enables or disables buffer packing for TCP/IP packets.
0 (default) is normal, the data buffer is packed before sending to the printer.
1 disables buffer packing, data is sent to the printer as it is received.
write-mode:
Controls the setting of the TCP PSH flag for device-to-client data transfers.
0 (default): disables this option, flag is not set.
1: all-push option. The push bit is set in all data packets.
2: eoi-push option. The push bit is set only for data packets that have an
End-of-Information flag set.
mult-tcp-conn:
Enables or disables multiple TCP connections.
0 (default) allows multiple connections.
1 disables multiple connections.
TCP/IP Raw Print Ports
raw-port:
Specifies additional ports for printing to TCP port 9100. Valid ports are 3000 to
9000, which are application dependent.
Table 3.3 TFTP Configuration File Parameters (2 of 8)
To Next Page
Loading...
