HP Jetdirect 610N - Page 50

50 TCP/IP Configuration EN
SNMP
snmp-config:
Enables or disables SNMP operation on the print server. 0 disables, 1 (default)
enables SNMP.
get-community-name:
Specifies a password that determines which SNMP GetRequests the HP Jetdirect
print server will respond to. This is optional. Specifies a password for SNMP
GetRequests sent to the HP Jetdirect print server. This password is optional. If a
user-specified get community name is set, the print server will respond to either a
user-specified community name or the factory-default. The community name must
be ASCII characters. The maximum length is 255 characters.
set-community-name:
Specifies a password that determines which SNMP SetRequests (control
functions) the HP Jetdirect print server will respond to. The community name of
an incoming SNMP SetRequest must match the print server’s “set community
name” for the print server to respond. SetRequests must come from hosts that are
configured in the print server’s host access list. Community names must be ASCII
characters. The maximum length is 255 characters.
auth-trap:
Configures the print server to send (on) or not send (off) SNMP authentication
traps. Authentication traps indicate that an SNMP request was received, but the
community name check failed. The default is “on.”
trap-dest:
Enters a host’s IP address into the HP Jetdirect print server’s SNMP trap
destination list. The command format is:
trap-dest: ip-address [community name] [port number]
The default community name is ‘public’; the default SNMP port number is ‘162’.
The port number cannot be specified without a community name, otherwise the
port number will become the community name.
If a ‘trap-community-name’ command is followed by ‘trap-dest’ commands, the trap
community name will be assigned to those entries unless a different community
name is specified in each ‘trap-dest’ command.
To delete the table, use ‘trap-dest: 0’.
If the list is empty, the print server does not send SNMP traps. The list may contain
up to five entries. The default SNMP Trap Destination List is empty. To receive
SNMP traps, the systems listed on the SNMP trap destination list must have a trap
daemon to listen to those traps.
trap-community-name:
Community name (password) included with SNMP traps that are sent by the
HP Jetdirect print server to a host computer. The default community name is
public
. Community names must be ASCII characters. The maximum length
is 255 characters.
Table 3.3 TFTP Configuration File Parameters (5 of 8)