HP Jetdirect 610N - Page 51

EN TCP/IP Configuration 51
IPX/SPX
ipx-config:
Enables or disables IPX/SPX protocol operation on the print server: 0 disables,
1 (default) enables.
ipx-unit-name:
A user-assigned alphanumeric name assigned to the print server (31 characters
maximum). By default, the name will be NPIxxxxxx, where xxxxxx are the last six
digits of the LAN hardware address.
ipx-frametype:
Specify the IPX frame type setting: AUTO (default), EN_SNAP, EN_8022,
EN_8023, EN_II, TR_8022, TR_SNAP.
ipx-sapinterval:
Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server
waits between Service Advertising Protocol (SAP) broadcasts on the network. The
default is 60 seconds. 0 disables SAP broadcasts.
ipx-nds-tree:
Identifies the name of the Novell Directory Services (NDS) tree for this printer.
ipx-nds-context:
An alphanumeric string, up to 256 characters, that specifies the NDS context for
the HP Jetdirect print server.
ipx-job-poll:
Specifies the time interval (seconds) that the HP Jetdirect print server will wait to
check for print jobs in a print queue.
ipx-banner:
Enables or disables printing an IPX banner page. 0 disables banner pages.
1 (default) enables banner pages.
ipx-eoj:
Enables or disables IPX end-of-job notification. 0 disables, 1 (default) enables.
ipx-toner-low:
Enables or disables IPX toner-low notification. 0 disables, 1 (default) enables.
AppleTalk
appletalk:
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server:
0 disables, 1 (default) enables.
Table 3.3 TFTP Configuration File Parameters (6 of 8)