52 TCP/IP Configuration EN
DLC/LLC
dlc/llc:
Enables or disables DLC/LLC protocol operation on the print server: 0 disables,
1 (default) enables.
Other Settings
scan-config:
Enables or disables the Web Scan feature on the print server when connected to
a supported device. 0 disables, 1 (default) enables.
scan-idle-timeout:
Specifies the number of seconds (1 - 3600) that an idle scan connection is allowed
to remain open. 0 disables the timeout. The default is 300 seconds.
scan-email-config:
Enable or disable the scan-to-email feature in the Web Scan server. 0 disables,
1 (default) enables.
MFP-config:
Enable or disable print server support of the client software provided with your
multifunction or all-in-one peripheral.
0 (default) disables client software support (allows printing only).
1 enables client software support (allows printing and scanning).
usb-mode:
Specifies the communication mode over the USB port on the HP Jetdirect print
server.
● Auto (default): Automatically negotiates and sets the the highest
communication mode possible for the attached printer or device.
● MLC: (Multiple Logical Channels) An HP-proprietary communication mode that
allows multiple channels of simultaneous print, scan and status
communications.
● BIDIR: A standard connection that supports bi-directional communications
between the printer and print server. The print server sends print data and
receives status from the printer.
● UNIDIR: A standard connection in which data is transferred in one direction
only (to the printer).
Table 3.3 TFTP Configuration File Parameters (7 of 8)
To Next Page
Loading...
