EN TCP/IP Configuration 57
10. Skip this step if you are not planning to use WINS (Windows
Internet Naming Service). Otherwise perform the following
steps when configuring your DHCP server:
a. From the DHCP Manager window, select DHCP Options
and select one of the following:
Scope — if you want Name Services only for the
selected scope.
Global — if you want Name Services for all scopes.
b. Add the server to the Active Options list. From the DHCP
Options window, select WINS/NBNS Servers (044) from
the Unused Options list. Select Add, then select OK.
A warning may appear requesting that you set the node
type. You do this in step 10d.
c. You must now provide the IP address of the WINS server
by doing the following:
d. Select Value, then Edit Array.
e. From the IP Address Array Editor, select Remove to delete
any undesired addresses previously set. Then type in the
IP address of the WINS server and select Add.
f. Once the address appears in the list of IP addresses, select
OK. This returns you to the DHCP Options window. If the
address you have just added appears in the list of IP
addresses (near the bottom of the window) return to step
10d. Otherwise, repeat step 10c.
g. In the DHCP Options window, select WINS/NBT Node
Type (046) from the Unused Options list. Select Add to
add the node type to the Active Options list. In the Byte box,
type 0x4 to indicate a mixed node, and select OK.
11. Click Close to exit to Program Manager.
To Next Page
Loading...
