Setting Up the Monitor
User’s Guide 3–5
Å
WARNING: To reduce the risk of electric shock or damage to your
equipment: Do not disable the power cord grounding plug. The
grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet that is
easily accessible at all times.
Disconnect power from the monitor by unplugging the power cord
from the electrical outlet.
Do not place anything on power cords or cables. Arrange them so
that no one may accidentally step on or trip over them. Do not pull on
a cord or cable. When unplugging from the electrical outlet, grasp
the cord by the plug.
Ä
CAUTION: Burn-in image damage may occur on monitors that
display the same static image on screen for a prolonged period of
time. To avoid burn-in image damage on your monitor screen, you
should always activate a screen saver application or turn off the
monitor when it is not in use for a prolonged period of time.
Selecting the Signal Connectors and Cables
There are two signal input connectors: one VGA connector and
one DVI-I connector. The monitor will automatically determine
which inputs have valid video signals. The inputs can be selected
through the On-Screen Display (OSD) feature or by pressing the
Signal Input 1 or 2 buttons on the monitor front bezel.
The video mode supported by the DVI-I connector is
determined
by the video cable used. For digital operation, use
the
DVI-D to DVI-D signal cable provided. For analog operation,
a DVI-A to VGA signal cable must be attached to the DVI-I input
(not provided with the monitor).
To Next Page
Loading...
Need help?
General
