To manually configure TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, and local and default gateway.
Setting an IP address
1. Press (HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet 5550 models) to
enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to select EIO X.
7. Press
to highlight TCP/IP.
8. Press
to select TCP/IP.
9. Press
to highlight MANUAL SETTINGS.
10. Press
to select MANUAL SETTINGS.
11. Press
to highlight MANUAL.
12. Press
to highlight IP ADDRESS.
13. Press
to select IP ADDRESS.
Note
The first of three sets of numbers is highlighted. If there is not a number highlighted, a
highlighted empty underscore appears.
14. Press
or to increase or decrease the number for configuring the IP address.
15. Press
to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct IP address is entered.
17. Press the P
AUSE
/R
ESUME
(HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet
5550 models) button to return to the Ready state.
Setting the subnet mask
1. Press (HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet 5550 models) to
enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to highlight MANUAL SETTINGS.
92 Chapter 3 Installation and configuration ENWW
To Next Page
Loading...