11. Press to select MANUAL SETTINGS.
12. Press
to highlight SUBNET MASK.
13. Press
to select SUBNET MASK.
Note
The first of three sets of numbers is highlighted.
14. Press or
to increase or decrease the number for configuring the subnet mask.
15. Press
to move to the next set of numbers.
16. Repeat steps 14 and 15 until the correct subnet mask is entered.
17. Press the P
AUSE
/R
ESUME
(HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet
5550 models) button to return to the Ready state.
Setting the syslog server
1. Press (HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet 5550 models) to
enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to highlight MANUAL SETTINGS.
10. Press
to select MANUAL SETTINGS.
11. Press
to highlight SYSLOG SERVER.
12. Press
to select SYSLOG SERVER.
Note
The first of four sets of numbers are the default settings. Each set of numbers represents
one byte of information and has a range from 0 to 255.
13. Press the
or arrow to increase or decrease the number for the first byte of the
default gateway.
14. Press
to move to the next set of numbers. (Press to move to the previous set of
numbers.)
15. Repeat steps 13 and 14 until the correct subnet mask is entered.
16. Press
to save the syslog server.
17. Press the P
AUSE
/R
ESUME
(HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet
5550 models) button to return to the Ready state.
Setting the local and default gateway
1. Press (HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet 5550 models) to
enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
ENWW Network configuration 93
To Next Page
Loading...