8. Close the ETB, the front cover, then the top cover. After a short while, the control panel
should display Ready.
Note
If a cartridge is in the wrong slot, the control panel displays the message Incorrect supplies.
9. Installation is complete. Place the used print cartridge in the box in which the new
cartridge arrived. See the enclosed recycling guide for recycling instructions.
Replacing the transfer unit (ETB)
Replace the transfer unit (ETB) when the printer control panel displays: REPLACE
TRANSFER KIT.
Note
If you replace the transfer unit when it is not at the end of life, for instance if it is defective,
you will need to calibrate the printer and reset the transfer unit count through the control
panel. See
Cleaning the static discharge comb for instructions.
Clean the static discharge comb whenever you replace the ETB. Use the new cleaning
brush that is included with the replacement ETB. See
Cleaning the static discharge comb.
1. Turn the printer off.
2. Using the side handles, open the top cover. Open the front cover.
3. Grasp the green handles on the transfer unit and pull down.
4. Locate the blue release latches on either side of the transfer unit (near the bottom of the
transfer unit).
ENWW Replacing supply items 111
To Next Page
Loading...