4. Grasp the ends and pull straight up to remove the fuser.
5. Remove the new fuser from the bag.
6. Grasp the sides of the fuser and lower it into the printer. Press firmly to seat it in position.
7. Tighten the blue thumb screws.
8. Close the top cover, and turn the printer on. After a short while, the control panel should
display NEW FUSER KIT.
9. Press
to highlight YES.
10. Press
to select YES.
11. Press
to reset the fuser count.
Replacing the fuser when it is not at end of life
If you replace the fuser when it is not at the end of its life (for example, if it is defective) you
will need to reset the fuser count through the control panel.
114 Chapter 4 Printer Maintenance ENWW
To Next Page
Loading...