HP Laser Jet 5550 - Page 135

5. Press to select PRINT QUALITY.
6. Press
to highlight CALIBRATE NOW (HP Color LaserJet 5500 models) or FULL
CALIBRATE NOW (HP Color LaserJet 5550 models).
7. Press
to select CALIBRATE NOW (HP Color LaserJet 5500 models) or FULL
CALIBRATE NOW (HP Color LaserJet 5550 models).
8. Wait for the printer to calibrate.
Use the following steps to reset the transfer unit count:
1. Press
HP Color LaserJet 5500) or M ENU (HP Color LaserJet 5550 models) to open the
MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight RESETS.
5. Press
to select RESETS.
6. Press
to highlight RESET SUPPLIES.
7. Press
to select RESET SUPPLIES.
8. Press
to highlight NEW TRANSFER KIT.
9. Press
to select NEW TRANSFER KIT.
10. Press
to highlight YES.
11. Press
to reset the transfer unit count.
Replacing the fuser
Replace the fuser when the printer control panel displays REPLACE FUSER KIT.
1. Turn the printer off.
2. Using the side handles, open the top cover.
WARNING!
The fuser might be hot. Wait 10 minutes before proceeding.
3. Completely loosen the blue thumb screws on either side of the fuser.
ENWW Replacing supply items 113