5. Pull the cover up and back to remove it.
Figure 6-5.
Removing and replacing the rear top cover
Left cover
Use the following steps to remove and replace the left cover.
To remove the left cover
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Open the front cover.
5. Remove the two screws at the bottom of the left cover shown in callout 1.
6. Disengage the two tabs shown in callout 2.
7. Tilt the top of the left cover away from the printer, and remove it.
192 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...