To remove the right cover
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Open the front cover.
5. Remove the two screws shown in callout 1.
6. Disengage the four tabs shown in callout 2.
7. Tilt the top of the right cover away from the printer and remove it.
Reinstallation tip
When reinstalling the right cover, be sure to insert the two hooks that are along the bottom
edge of the cover into the holes in the printer frame.
Figure 6-8.
Removing and replacing the right cover
Multi-purpose tray (Tray 1)
Use the following steps to remove the multi-purpose tray (Tray 1).
To remove the multi-purpose tray
1. Remove Tray 2 from the printer and set it aside.
Note
If the tray is difficult to remove because the front cover will not close completely, make sure
the ETB supports are rotated up into the printer. See
Figure 6-2. ETB supports and pressure
gears.
2. Open the multi-purpose tray (Tray 1).
3. Unhook the two link arms shown in callout 1.
194 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...