4. Flex the cover inward near the two link arms, and remove the cover.
Figure 6-9.
Removing and replacing the multi-purpose tray
Front cover
Use the following steps to remove the front cover.
To remove the front cover
1. Remove the multi-purpose tray. See Multi-purpose tray (Tray 1).
2. Unhook the two spring rods shown in callout 1.
CAUTION
The rods are under spring tension. Use caution when removing them. Tilt the tray up to
lessen the spring tension, making the rods easier to remove.
3. Remove the four screws shown in callout 2, and remove the rod supporting plates.
ENWW Covers and external components 195
To Next Page
Loading...