4. Remove the front cover.
Figure 6-10.
Removing and replacing the front cover
Control panel
Use the following steps to remove the control panel and install a control panel overlay.
To remove the control panel
1. Remove the top cover. See Top cover.
2. Remove the rear top cover. See
Rear top cover.
3. Remove the right cover. See page
Right cover.
4. Remove the two screws shown in callout 1.
5. Lift the right side of the control panel to access the connector underneath the left side.
6. Disconnect the connector shown in callout 2, and unwind the wires from the stay.
196 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...