Internal components (front)
Use the following steps to remove and replace the front internal components of the printer.
Paper pickup unit
1. Unhook the two tabs shown in callout 1, and remove the pickup unit cover.
2. Disconnect the connector shown in callout 2.
3. Remove the two screws shown in callout 3, and remove the paper pickup unit.
Figure 6-16.
Removing and replacing the paper pickup unit (1 of 2)
Figure 6-17.
Removing and replacing the paper pickup unit (2 of 2)
ENWW Internal components (front) 199
To Next Page
Loading...