Cassette sensor PCB
Use the following steps to remove the cassette sensor PCB.
To remove the cassette sensor PCB
1. Remove the paper pickup unit. See Paper pickup unit.
2. Remove the two screws shown in callout 1.
3. Disconnect the connector shown in callout 2, and remove the cassette sensor PCB.
Figure 6-18.
Removing and replacing the paper pickup sensor PCB
Note
The side view is shown in callout 1.
Multi-purpose tray sensor PCB
Use the following steps to remove the multi-purpose tray sensor PCB.
To remove and replace the multi-purpose tray sensor PCB
1. Remove the paper pickup unit. See Paper pickup unit.
2. Remove the two screws shown in callout 1.
200 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...