6. Remove the three screws shown in callout 5, and remove the lifter drive unit.
Figure 6-24.
Removing and replacing the lifter drive unit (3 of 3)
Cassette (Tray 2) paper pickup and feed rollers
Use the following steps to remove the paper pickup and feed rollers.
To remove the paper pickup and feed rollers
1. Remove the cassette.
2. Locate the two rollers on the bottom of the paper pickup unit (above the cassette). The
pickup roller is the smaller roller, and the feed roller is the larger roller.
3. Pinch the tab on the end of the cassette pickup roller (callout 1), and pull the roller out.
204 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...