4. Pinch the tab on the end of the cassette feed roller (callout 2), and pull the roller out.
Figure 6-25.
Removing the cassette pickup and feed rollers
Note
Always replace the cassette pickup roller and the cassette feed rollers at the same time.
Also replace the separation roller (located in the paper cassette) when replacing these rollers.
Solenoid and clutch
Use the following steps to remove the multi-purpose tray solenoid or cassette clutch.
To remove the multi-purpose tray solenoid or cassette clutch
1. Remove the paper pickup unit. See Paper pickup unit.
2. To remove the multi-purpose tray solenoid, remove the screw shown in callout 1 and
disconnect the connector shown in callout 2.
3. To remove the cassette clutch, disconnect the connector shown in callout 3, and remove
the spring shown in callout 4.
4. Remove the three screws shown in callout 5, and remove the side plate.
ENWW Internal components (front) 205
To Next Page
Loading...