Multi-purpose tray separation pad
Use the following steps to remove the multi-purpose tray separation pad.
To remove the multi-purpose tray separation pad
1. Remove the multi-purpose tray pickup roller. See Multi-purpose tray pickup roller.
2. To provide easier access to the separation pad, remove the e-clip from either of the
black rollers and slide the rollers out of the way (callout 1).
3. Press down on the separation pad holder and unhook the two tabs on the separation
pad (callout 2).
4. Rotate the separation pad forward and remove it.
Figure 6-30.
Removing and replacing the multi-purpose tray separation pad
Color registration detection unit
Use the following steps to remove the color registration detection unit.
To remove the color registration detection unit
1. Open the top cover and the front cover.
2. Remove the ETB.
Note
To protect the ETB from damage, always remove the ETB when removing the color
registration detection unit.
3. Remove the control panel. See
Control panel.
4. Disconnect the connector shown in callout 1.
208 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...