To remove the low-voltage power supply
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Remove the left cover. See
Left cover.
5. Remove the DC controller shield. See
DC controller shield.
6. Remove the right cover. See
Right cover.
7. Disconnect the two connectors shown in callout 1.
Figure 6-52.
Removing and replacing the low-voltage power supply, left side of printer (1 of 4)
8. At the rear of the printer, remove the four screws shown in callout 2.
9. Remove the cables from the cable clips, and remove the power supply cover.
Figure 6-53.
Removing and replacing the low-voltage power supply, rear of printer (2 of 4)
224 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...