10. On the right side of the printer, unhook the switch rod from the low-voltage power
supply, shown in callout 3.
11. Remove the two screws shown in callout 4.
12. Disconnect the connector shown in callout 5.
Figure 6-54.
Removing and replacing the low-voltage power supply, right side of printer (3 of 4)
13. At the left rear corner of the printer, remove the screw shown in callout 6.
14. Disconnect the connector shown in callout 7.
15. Slide the low-voltage power supply unit (callout 8) out of the printer.
Figure 6-55.
Removing and replacing the low-voltage power supply (4 of 4)
Formatter case
Use the following steps to remove the formatter case.
ENWW Internal components (rear) 225
To Next Page
Loading...