20. Unhook each laser/scanner unit from the white strap shown in callout 8. Then pull the
laser/scanner units out of the printer.
CAUTION
When reinstalling the laser/scanner units, always reconnect the laser/scanner units to the
strap. Failure to do so could cause the laser/scanners to become distorted, and the laser
beam could become skewed, resulting in image defects. Also check that the scanners are
aligned and seated properly.
CAUTION
The laser/scanner unit is not adjustable in the field. Do not disassemble it.
Figure 6-65.
Removing and replacing the laser/scanner units (8 of 8)
232 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...