Internal components (right side)
Use the following steps to remove and replace the right side internal components of the
printer.
High-voltage power supply PCB
Use the following steps to remove and replace the high-voltage power supply PCB.
To remove the high-voltage power supply PCB
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Remove the right cover. See
Right cover.
5. Remove the four screws and the mount retainer shown in callout 1.
6. Pinch the four clips shown in callout 2, and free the board.
7. Disconnect the connector shown in callout 3.
8. Remove the high-voltage power supply PCB.
Figure 6-66.
Removing and replacing the high-voltage power supply PCB
ENWW Internal components (right side) 233
To Next Page
Loading...