Reinstallation tip
When reinstalling the high-voltage power supply PCB, be sure to align the white markings on
the left side of the PCB with the hooks on the printer, then snap in the PCB. You can verify
that the PCB is aligned correctly by observing the 12 holes shown in callout 4. When the
PCB is aligned correctly, you will be able to see part of the contact springs, as shown in
callout 5.
Figure 6-67.
Aligning the high-voltage power supply PCB
Toner level detection PCB
Use the following steps to remove the toner level detection PCB.
234 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...