8. Remove the discharging PCB.
Figure 6-72.
Removing and replacing the discharging PCB
Fuser power supply PCB
Use the following steps to remove the fuser power supply PCB.
To remove and replace the fuser power supply PCB
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Disconnect the connector shown in callout 1, and unthread the cable from the stay.
5. Unthread the cable shown in callout 2 from the fuser power supply cover.
ENWW Internal components (top) 239
To Next Page
Loading...